Jensen Compatible Ironer Belt, Cotton 50mm × 2655mm – 70552655Cotton flatwork ironer belt for Jensen systems. Pre cut to OEM spec. 50mm wide 2655mm long. Drop in replacement no cutting, no measuring required. Specifications Part Number: 70552655 Width: 50mm Length: 2655mm Material: Cotton Compatible With: Jensen End Treatment: w pin DISCLAIMER: All brand names are trademarks of their respective owners. These products are compatible replacement parts and are not manufactured, authorized, or endorsed by the

Rubberized Ironer Belt — 2" x 74

Milnor Shaft 4244Sg2 (Tunneltype) [02-16295S]

allowing fast replacement without reworking drive components

335 [500/I14]

It supports consistent rotation and load handling in washer and dryer drive systems where proper belt tension and alignment are critical to operation

Castrol Pyroplex Red EP2 Grease delivers the performance and reliability you need to keep your machines running smoothly and efficiently

The canvas construction provides durability under continuous contact and moderate heat exposure typical of ironer discharge zones

Forenta Dicsonnect Switch [33319]

allowing smooth rotation while maintaining correct drum alignment within the cabinet structure

Specs pending: bore

Rodless cylinders are typically installed in rail-guided or carriage-driven mechanisms where synchronized motion and reduced envelope size are critical

CICUS supplies field-matched pneumatic control components engineered for commercial flatwork systems