Axle Spacer Kit, Front 10mm, 996TT, 997TT, 991TT, & 992TTDescription: Finally a solution that allows you to safely increase front camber, with GT3 LCA shims, but without the risk of damaging the transmission or front axles on your Porsche Turbo or C4. As you add shims to your front LCA's, you move the CV joints closer to and beyond their safe range of motion, risking failure and expensive damage. These 10mm thick precision spacers, used with 16mm of LCA shims will provide an additional 1. 7 deg. of camber,

Quality 17-4 PH Stainless Steel parts

4 Swift helper springs with spacers and thrust plates

If the GiroDisc caliper spacers are 7mm or more

and contribute to imprecise shifting and inferior throttle response

This front splitter will add a functional aerodynamic improvement for your Porsche

Note:  Shown with optional boots

There is absolutely no other like it

especially under track conditions

These semi solid mounts offer more precise location than the factory RS mounts - and do so at a lower price

Solid thrust arm bushings and sealed monoball inner ends are used to eliminate the spongy rubber OEM bushings and provide a precision ride for improved feedback

Its empty voids allow for too much engine movement

The pulley is fully balanced and is a 16% reduction